How to Send a Noble Train in Under 200
Note: I will be using rams as the train, they will act as the Noblemen.
So I've decided that now it's time to show you how to send an extremely quick noble train. The advantages of this means it is extremely hard for others to split it. However, unlike the other noble train guide (#1) I showed you - this one is far
more unreliable and should not
generally be used when attacking others. It is more for bragging purposes, enhancing your skill and showing us that you can
This guide is extremely similar to the first guide except for the actual sending of the attacks part.
Firstly, we must look at what is a noble train. A noble train is a string of four or five nobles in a short time-span. Now, let's get right into it:
- So, you pick your target. You then click on their village and open four
tabs for it. Do that by doing the following:
You should then have four tabs open, all
of which are on your rally point. You then enter your troops. Put the majority
of your troops in the first attack, with small amounts in the others. Here's what it should look like:
^ Note the four tabs as shown before.
- Click attack
on each tab. You then have each tab looking look this:
^ Note you don't necessarily have those troop numbers. But each tab should have their attack command window up like that.
- Next, you RIGHT CLICK
on each of the OK
buttons. You'll notice when you've done this as it'll change a bit. It'll then look like this:
^ All your OK
buttons on your attack command windows should then look like this.
- So now you have all the tabs lined up. Troop numbers in. Attack button clicked. And the OK button ready to tap.
- Next, it's time to send the attacks. This is where all the above work comes in handy. You go back to your first tab and get yourself ready. This part is more complicated than in the previous guide, but if you follow the following steps it should work fine:
(i) Go to the first tab.
(ii) Hold down the "2" button on your number-pad. You will notice that it switches between the four tabs extremely
quickly as you hold this down.
(iii) Position your cursor over
the OK button in the attack windows (whilst still holding 2 down)
(iv) Begin rapidly
and keep doing so for about 20 seconds. (whilst still holding 2 down)
What this does is it lags the server (for you, only). It doesn't send the attacks as you are rapidly switching between the tabs and constantly clicking OK so the page doesn't have time to refresh. Due to this, when you finally do stop clicking OK and it refreshes, the attacks are extremely close together.
However, there are a few drawbacks of this:
(i) Often you get it under
150 milliseconds and it is therefore illegal and will have to be cancelled.
(ii) Your nuke often does not come first in the attack. For that reason it is not recommended for first-timers as you will have to send your four nobles with a small escort each, and time your nuke (at ram speed) in front of the first noble (or cancel and resend until the nuke comes first)
However, all that being said - it is a good trick to know.
Then, you should have an attack like the following:
Jan 18, 2010 15:50:07:806
Jan 18, 2010 15:50:07:814
Jan 18, 2010 15:50:07:896
Jan 18, 2010 15:50:07:936
That attack is 130 Milliseconds
from start to finish and is therefore illegal
, and will have to be cancelled as I pointed out earlier is often the case.
That just about covers it.
This is the way to send a quick train.